Request a quote
Emergency SectorsCareers About us Blog Get in touch
Night-time skyline seen from above, with blue lines of light on a tower block

Point to point wireless between buildings: when it replaces fibre, and when it does not

A point to point wireless link connects two buildings without digging a trench. That makes it attractive as soon as a road, a railway or a river sits between the office and the warehouse. Whether it can replace a cable there depends on three things a quote rarely mentions: what can get in the way between the two roofs, which spectrum it uses, and what happens when it drops for an afternoon.

7 min read Written by the ITproposal team
Short answer

A point to point wireless link is your own wireless bridge between two of your buildings, not an internet line. The networks on both sides become one network.

It replaces a cable well where digging is expensive, slow or impossible, or as a second path alongside a cable already in the ground. It replaces it badly where there is no clear line of sight or where an outage is not acceptable.

Line of sight, weather and spectrum decide reliability more than the speed on the box. Ask about the path and the second route first, and about the megabits last.

What a point to point wireless link is, and what it is not

A point to point wireless link, sometimes called a wireless bridge, is two radios with directional antennas aligned on each other. Each building gets one, usually on the roof or a wall, connected by a network cable to a switch inside. To the network it then behaves like a cable: devices in the warehouse sit on the same network as those in the office, with the same VLANs and the same rules.

It is two things it is not. It is not an internet connection. It joins two sites of your own, and internet still comes in through the line you already have; how to choose that is covered in our page on business internet. And it is not Wi-Fi. An access point spreads signal in every direction for devices that move; a point to point link is one narrow beam between two fixed points, which is exactly why it reaches so far.

When point to point wireless replaces fibre, and when it does not

The question is rarely “wireless or fibre” in general. It is: what does a cable cost here, and what does it cost when this link goes down?

A wireless link fits well when:

  • a public road, railway, water or someone else’s land lies in between. Digging then means permissions, a contractor and months of lead time;
  • the link is temporary, such as site cabins, a temporary classroom or a short-term warehouse;
  • it is needed quickly, for instance when a team moves to the building across the road;
  • there is already a cable and you want a second path that does not share the same trench. A digger that cuts the cable does not cut the air.

A cable stays the better choice when ducting is already in place, there is no clear sight between the buildings, the link carries a production process or tills that cannot stop for an hour without a second route, or the distance grows to the point where weather starts to matter. A wireless link is still possible then, but as the second path, not the only one.

Line of sight, distance and weather

A wireless link needs clear line of sight, and more than a straight line between the antennas. The signal travels in a cigar-shaped zone around that line (the Fresnel zone), and a tree canopy, a parapet or a lamp post intruding into it costs signal even when you can see the far antenna with the naked eye.

So do not only look at today. Trees grow and come into leaf in summer. A new building or a tower crane appears. A link perfectly aligned in February can be weaker in June. Ask whether the installer has modelled the path profile and what fade margin remains.

Then the weather. The higher the frequency, the more capacity is available and the more sensitive the link is to heavy rain. Over short distances you hardly notice; as distance grows it becomes a design question. Wind matters too: an antenna on a light pole or a loose bracket loses its alignment in a storm. Mounting must be solid, and that is work on the building.

Licence-exempt or licensed spectrum

There are two kinds of spectrum, and the difference matters more than the brand of radio.

  • Licence-exempt bands, such as 5 GHz and 60 GHz. You apply for nothing, but you share the band with everyone nearby. Wi-Fi networks and other links also use 5 GHz, so interference from a neighbour is possible and cannot be prohibited. 60 GHz tolerates crowding better because the beam is narrow and short, but that also limits it to short distances.
  • Licensed bands. The regulator assigns a frequency to that one link, so it is yours. That takes an application and lead time, and buys predictability you cannot get in a shared band.

Each country sets its own rules on which bands are open and how; in the UK that is Ofcom. For every quote, ask which band the radio uses, whether a licence or registration is needed, and in whose name it will be held.

The roof, the cable and lightning

The part most often forgotten is not in the radio but in the building.

  • Permission. If you rent, the landlord decides about an antenna on the roof or wall. If the building across the road belongs to someone else, you need the same permission there. Get it in writing, including access for maintenance.
  • The cable inside. The radio is usually powered over the network cable (PoE). That cable has to pass through the roof or wall, watertight, to a switch that supplies PoE. From there it is ordinary structured cabling.
  • Surge protection and earthing. An antenna on the roof is a point where lightning and surges can get in. A surge protector on the cable and earthing in line with the building’s installation are not optional; without them a thunderstorm takes the switch with it.
  • Access. A radio that can only be reached with a cherry picker does not get checked. Choose a place you can reach safely.

What runs over the link

The speed on the box is the radio rate, not what is left. Part of it goes on protocol overhead, and when the signal weakens the radio drops to a lower rate. Ask for the expected throughput at this distance with this margin, and measure it after installation.

Three arrangements for the network behind it:

  • Encryption on. A narrow beam is hard to intercept, not impossible. Modern radios encrypt the link; check that it is enabled and that the admin password is not the default.
  • Monitoring. A wireless link often degrades gradually before it fails. Watching signal strength and throughput shows you a growing tree or a shifted bracket before it becomes an outage.
  • A second path, or a plan. What happens in the warehouse when the link is down? Does it keep working on its own internet line, or does everything stop? Decide that in advance, not during the outage.

Six questions before you order a point to point wireless link

  • Has the path been modelled, including trees, planned buildings and the Fresnel zone, and how much margin is left?
  • Which band does it use, is it licence-exempt or not, and who applies for any licence?
  • What throughput is expected at this distance, and will it be measured and recorded at handover?
  • Who arranges the mounting, the landlord’s permission and the surge protection?
  • How is it monitored, and who is alerted when the signal fades?
  • What is the second path, or what is agreed when the link fails?

Where our work stops

What we do. We design and manage the network on both sides, advise on wireless or cable, supply and configure the radios, connect them to switches and VLANs and monitor them afterwards. We also say so when a wireless link is not a good idea at a site.

What we do not do. We are not a building contractor: masts, roof penetrations and structural work are construction work. We are not the regulator and do not assign spectrum; a licence is held in the name of the organisation that applies for it. And permission for an antenna on a roof comes from the owner of that roof, not from us.

Frequently asked

Questions we get about this

The five that come up most often.

What is a point to point wireless link?

It is a wireless connection between two fixed points, using two radios aimed at each other. Between two buildings it works like a network cable through the air, putting both sites on the same network. It does not replace an internet connection; you still need one.

Is point to point wireless as reliable as fibre?

With clear line of sight, solid mounting and the right frequency it can be very reliable. It is, however, exposed to things fibre is not: growing trees, new buildings in the path, heavy rain at higher frequencies and interference in shared bands. Where an outage is unacceptable, put a second path alongside it.

Do you need a licence for a point to point wireless link?

It depends on the band. Bands such as 5 GHz and 60 GHz are licence-exempt and shared with others; for other bands the regulator assigns a frequency to your link. Each country sets its own rules, in the UK through Ofcom. Ask which band is used and what it requires before you sign.

When is a wireless link better than digging a trench?

When a public road, railway, water or someone else’s land lies between the buildings, when the link is temporary, or when it is needed quickly. It is also useful as a second path alongside an existing cable, because it does not share the trench. If ducting is already in place, the cable almost always wins.

Do you install the mast on the roof as well?

No. We supply, configure and manage the radios and the network, but masts, roof penetrations and structural work on a building are a job for a contractor. Permission for the antenna comes from the building owner, and any spectrum licence is held by the organisation that applies for it.

Related services

Further reading

What a wireless link connects to.

Two buildings, one network?

Send us both addresses and what lies between them. We will tell you whether a wireless link fits there, which questions are still open and what has to be arranged at the buildings.

Practical IT knowledge in your inbox

New guides on management, security and the workplace, written by the people doing the work. No sales talk, and you can unsubscribe in one click.

We use your address for the newsletter only. See our privacy policy.

Request a quote Call